5/24/2023 0 Comments Rssi 68![]() What are the recommended settings for the power? Is it best practice to go with the defaults (Max 30 dBm/Min -10 dBm)? Reading the following post from Araon ( ) he recommended -74dBm based upon the output from the show ap auto-rf 802.11b.When a Neighboring AP is no longer “heard” at -85 dBm or better, is the RF coming from the AP considered interference, co-channel interference if the two APs are on the same channel, Foreign Interference, or noise? I think it is co-interference but I am not sure. ![]() What is the default dBM an AP needs to receive/ “hear” a Neighbor Message at? Towards the beginning of the document, it states “…WLCs will add neighbors to their lists given they are heard at greater than or equal to -80 dBm and will only then remove them once their signals dip below -85 dBm.” However, towards the middle of the document, it states “the RF Group Leader will apply the TPC algorithm on a per-band, per-AP basis to adjust AP power transmit levels downward such that the third loudest neighbor AP will then be heard at a signal level of -70dBm (default value or what the configured value is) or lower and the TCP hysteresis condition is satisfied.”.From reading Cisco’s Radio Resource Management under Unified Wireless Networks (Document ID: 71113) and the following Post ( ), I have a few questions which I am trying to get some clarification.
0 Comments
Leave a Reply. |